SimplyCam V3. Documentation

• SimplyCam V3
  • Introduction
• Interface
  • Zoom and Pan
  • Status Bar
  • Snap
  • Layer
• Toolbars
  • File toolbar
  • Create toolbar
  • Edit toolbar
  • View toolbar
  • Status Bar
• Vectorization
  • Vectorize
• Settings
  • Settings
• Toolpath Manager
  • Simulation
  • PostProcessor
• Mill Toolpaths
  • Contour
    • Tools
    • Profiles
    • Parameters
      • Lead In/Out
      • Tabs
  • Pocket
    • Tools
    • Profiles
    • Parameters
      • Lead In/Out
  • Drill
    • Tools
    • Points Select
    • Parameters
  • Parallel
    • Tools
    • Size/Limits
    • Parameters
• Laser, Plasma, Waterjet Toolpaths
  • Cut
    • Tools
    • Profiles
    • Parameters
      • Lead In/Out
      • Tab
  • Laser Engraving
    • Tools
    • Parameters
• Lathe Toolpaths
  • Lathe Rough
    • Tools
    • Profiles
    • Parameters
  • Lathe Finish
    • Tools
    • Profiles
    • Parameters
• Mill tutorials
• Laser, Plasma, WaterJet tutorials
• Lathe tutorials

Lathe Lead in/out

These dialogs allows you to add an Entry and/or an Exit vector to the finishing and/or roughing cuts.

Length
Sets the length in degrees of the entry/exit vector.

Direction
Sets the direction in degrees of the entry/exit vector.

Copyright ©2015 MR-Soft  -   SimplyCam version 3.0.6  -   Help file built on 12/08/2015